Final Assembly
Last updated
Was this helpful?
Last updated
Was this helpful?
To test out your print you'll need to do some minor assembly. Start by trimming the PET to the printed outline. Be careful to not cut through any of the interior traces.
Next, Add some tape around the finger stylus to hold its shape.
Carefully pull down the black tabs on the connector of the companion board. This will allow you to insert your printed design.
Next, plug your printed cable end into the connecter at the bottom companion board and gently close the two black connector tabs to lock it in place.
You're now ready to test the board out. The power button is in labeled in the center of the board. With the left potentiometer you can control the volume and with the right potentiometer you can control the pitch to tune the keyboard.
Finally, using the printed finger stylus you can play the keyboard by making contact with the keys.
And that's it! Your first print is complete. We always love seeing prints in action, so feel free to tag us in any social media posts. Here's where you can find us:
