For the complete documentation index, see llms.txt. This page is also available as Markdown.
Gantry LED Strip Replacement
Repair guides are to be used when directed by Voltera Support only!
Performing these without Voltera Support's direction could be the wrong resolution path for your issue and could cause damage to your machine. If you haven't been in contact with Voltera Support about your issue please email support@voltera.io or reach out in the chat before proceeding.
Before you begin
This guide will take you through replacing the control board in NOVA. Before beginning this guide you should have been in contact with our support team and received replacement parts.
As you work through this guide please reach out to our email support@voltera.io or through the chat if you run into any issues or have any questions. We are more than happy to assist you virtually with this repair.
When in doubt, reach out!
Estimated Repair Time:
20 minutes
Tools you will need:
Screwdriver
T20 Torx (Magnetized)
Parts you have received from Voltera:
LED Strip PCB
Replace the LED Strip
1
Disconnect NOVA from power
Ensure that NOVA is turned off with the power button and then unplug the power cable.
2
Remove the backplate
With a T20 Torx bit remove the 6 screws (2 on the back side, 4 on the bottom of the panel) securing the back panel. Once the screws are out you can pull the back panel out by tilting it up slightly and then pulling away from the machine.
3
Remove the LED Strip
Disconnect the cable connected to the LED strip.
With a T20 Torx bit remove the single screw securing the LED Strip bracket to NOVA.
Either magnetize your bit to ensure that the screw does not fall into NOVAs body or slowly slide the LED strip out with the screw as you loosen it.
Slide the LED Strip PCB out of NOVA.
4
Install the new LED Strip PCB
Slide the new LED Strip PCB into NOVA by aligning it with the internal channel.
With a T20 Torx bit insert the single screw and secure the LED Strip bracket to NOVA and plug in the cable.
5
Reattach the backplate
Put the back plate back into place and with a T20 Torx bit secure the 6 screws (2 on the back side, 4 on the bottom of the panel).
6
Turn NOVA back on!
You can now plug NOVA back in and turn it on using the power button to test if the LED strip is functioning.
Repair Complete!
Congratulations, you have successfully replaced one of NOVAs LED Strips!
Please reach back out to our support team through email (support@voltera.io) or the chat to let them know everything went well. We will arrange a shipping label to return the old parts back to us for further testing.
